Need Assignment and Lab Completed

AssignmentOp-Amp Noise TheoryRead Appendix B in the text.Answer the following questions:Calculate the signal to noise ratio given RMS Noise Voltage = 10mV and RMS Signal Voltage = 1VCalculate ETotalRMS given e21RMS = 4V and e22RMS = 8VCalculate SNR(dB) given a noise specification of 500.5nVCalculate the noise specification given SNR(dB) = 150dBInclude all calculations in a Word document with the title: “HW7_StudentID”, with your student id substituted in the file name.  Show all work for full credit.Upload file “HW7_StudentID”LabOp-Amp Noise TheoryThe purpose of this lab is to learn to use Multisim to analyze noise in op-amp circuits. Students will capture screenshots of the noise spectral density curves which will provide a visual relationship of the output noise voltage versus frequency.Read the document on configuring a noise analysis in Multisim. Week 7 – Configuring Noise Analysis in Multisim.pdfFollowing the instructions in pdf, construct the inverting Op-Amp circuit shown in figure 1.Run the simulation to measure the gain of the Op-Amp and record the values of R1 and R2 and the measured gain in the table below. (Use 5% tolerance for R1 and R2)For the gain of 5 in the table above, run the noise analysis to obtain the results for noise voltage for R1 and R2. (Note: You need to run this noise analysis for the circuit with the gain of 5 only)Plot the noise spectrum density curve across frequency range of 100 Hz to 1 GHz. (Note: If your Multisim version does not support this option then try to download the trial version of Multisim Power Pro edition from NI website).Answer the following questions:Does the measured gain values match the given values? If not, explain why they are different?From the noise spectral density curve, explain the effect of increasing the frequency on the noise voltage.Is the voltage gain of the Op-Amp dependent on frequency? Please explain.Create a new word document called “Lab7_StudentID.docx” with your GID substituted into the file name.Verify all calculations from analysis and measurements from simulations. Save the results along with the table and paste the screen captures in the word document. Make sure to answer the questions.Upload file “Lab7_StudentID” in Blackboard.